Please click HERE for a downloadable PDF copy of Eagle i Remote Monitoring System Commands.

EAGLE i ● COMMANDS

  • OUTPUTS Requests the status of the outputs.
  • INPUTS Requests the status of the inputs.
  • LEVEL Requests the water level status.
  • RESET Resets a VFD fault.
  • SPEED Requests the pump's speed status.
  • TIME Requests the accumulated run time.  The maximum run time is 9999 hours.  To reset the run timer, use the command "IOIAS2=0".
  • CYCLES Requests the accumulated cycles. The maximum number of cycles is 9999.  To reset the cycle counter, use the command "IOIAT2=0".
  • IOOH1 Turns the minimum speed limit on.
  • IOOL1 Turns the minimum speed limit off.
  • IOOH2 Turns the VFD operations off (disables the drive).
  • IOOL2 Turns the VFD operations on (enables the drive).
  • AIN0H=<value> Changes the high-level alarm set point.  For example:  AIN0H=85 will set the set point to 85 inches of water.
  • AIN0L=<value> Changes the low-level alarm set point.  For example:  AIN0HL=4 will set the set point to 4 inches of water.
  • CS<n>=<phone number> Adds a telephone number to the authorized list.  There are 10 available spaces for phone numbers, represented by the <n> (0-9).  The phone number must be entered without a "1" prefix or any dashes.  For example:  CS0=9897378374 would add the telephone number (989) 737-8374 to the “0” space on the list.
  • CS<0> Deletes the delete the phone number in the “0” position.   For example:  CS0 will delete the phone number in the “0” position.
  • CS? Reads or displays all the authorized phone numbers on the unit's list.
  • IOIP=2 Disables sending a text message every time the pump turns on and off.
  • IOIC=2 Enables sending a text message every time the pump turns on and off.
  • 999 Synchronizes the SMS controller to the time and date.